Page 404 - KAPPA - Ecrin v4.30 tutorials
Basic HTML Version
Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011
Rubis Guided Session #5: Thermal Option
• Rub
GS05 - 4/24
Fig. B02.2 • Reservoir geometry dialog
Click on OK to accept the current geometry.
B03 • Model Construction: Properties Definition
B03.1 • Defining Petrophysical Properties
Access the ‘Reservoir – Properties’ dialog by pressing on
.
Change the reservoir definition to ‘Layered’
to define
specific rock properties for each layer.
Select the ‘Shale 1’ layer in the table located on the left-hand part of the dialog, then click on
the
button below the table to create a new property set. Rename it ‘Shale’. Proceed
identically for each layer ‘S 1’ to ‘S 3’ and ‘L 1’ to ‘L 3’, assigning a different set to each layer.
Keep the ‘Default’ set for layer ‘L 4’. Assign the same property set ‘Shale’ for the layers
‘Shale 1’ to ‘Shale 3’. You should finally obtain the following table:
Fig. B03.1 • Region table
Select each property set in the table and set its petrophysical properties as shown below in the
table below, leave all the other values to the default:
