Page 320 - KAPPA - Ecrin v4.30 tutorials
Basic HTML Version
Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011
Rubis Guided Session #1
• Rub
GS01 - 6/33
After the load is completed the data
are displayed in the left-hand side
table and the current interpolated
map is displayed on the right-hand
side:
Note that this dialog can be resized
by dragging the bottom right corner.
The interpolation method that is
used by default is Linear
interpolation as can be seen when
clicking on the ‘Interpolation’ tab
. Press OK to validate.
In a similar manner, change the thickness of the Sand layer from ‘Constant’ to ‘Data set’, and
click on the button again to define the corresponding data points. This time, we will not use
a predefined file, but pick the thickness points on the screen. Click on the
button to
directly define the data set point by point on the right-hand side plot. The desired thickness is
entered at the bottom left, and the points with this thickness value are picked next. Impose a
thickness of 50 ft in the south-west of the reservoir and 40 ft in the north-east, with a
maximum thickness of 70 ft in the center, as displayed below:
