Page 319 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011 Rubis Guided Session #1 • RubGS01 - 5/33
In the dialog above, change the number of layers to 3, and in the table rename the top layer
(Layer 1) to ‘Sand’, the middle layer to ‘Shale’ and the bottom layer (Layer 3) to ‘Bottom’.
Then, change the top horizon of the ‘Sand’ layer from ‘Constant’ to ‘Data Set’. The dialog
should then present the following display:
Fig. B02.5 • ‘Reservoir – Geometry’ dialog, 3 layers being now defined
Click on to enter the data points
that will be used to define the
surface of the top horizon. The ‘top
– Sand’ Data Set definition dialog
will then show up:
In this dialog, click on to load
the data points from the file called
‘RubGS01_TopHorizon.asc’.
This file contains tabulated data for
the top horizon of the reservoir in a
{x,y,top} format. Select ‘Load’ to
load the points.