Page 458 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.30 - Doc v4.30.01 - © KAPPA 1988-2013 Rubis Guided Session #7 • RubGS07 - 12/19
Last but not least, we will now precise the composition of the gas phase being injected: to
achieve so, click on the ‘Injection Hydrocarbon Composition’ button in the Injector – controls
dialog and set the injected fluid molar composition as in Figure E01.7:
Fig. E01.7 • Injected fluid composition dialog
By doing so, we just specified that the injector well will actually not re-inject the same fluid as
the one produced, but only the light component…
Before to proceed with the simulation of the problem, create a cross-section going through
both wells in the reservoir, as shown below:
Fig. E01.8 • Cross-section path