Page 457 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.30 - Doc v4.30.01 - © KAPPA 1988-2013 Rubis Guided Session #7 • RubGS07 - 11/19
Even though we will not spend time defining each model in details and keep all defaults
instead, we will set the wellbore model to ‘All trajectory’ for the producer well, and to ‘Only
hydrostatic gradient’ for the injector, as shown below:
Producer Injector
Fig. E01.4 • Setting wellbore models for the different wells
We will now define a unique well control for each of these wells, and set that the producer is
following a surface gas rate target of 200 Mscf/D, whereas the injector is re-injecting the same
amount (we can keep the default constraint pressure values). In essence, you should end-up
with the display shown in Fig. E01.5 and E01.6:
Fig. E01.5 • Well control dialog for the producer
Fig. E01.6 • Well control dialog for the injector