Page 415 - KAPPA - Ecrin v4.30 tutorials
Basic HTML Version
Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011
Rubis Guided Session #5: Thermal Option
• Rub
GS05 - 15/24
C02.2 • Initialization
Click on ‘Initialize’
in the
page to launch the problem initialization: the
initial state is computed, and the different steps are listed in the activity report located in the
lower part of the ‘Simulation’ tab.
C03 • Simulation: Run Simulation and Results Visualization
C03.1 • Run Simulation
Click on ‘Simulate’
to start the simulation thread: the simulation is initiated and results
are displayed in real time as the run goes on. Note that it is possible to perform any action on
the output plots (delete, create new, maximize, zoom in, etc...) as the simulation runs.
C03.2 • Looking at Well Results
The plot ‘Gauges – P01’ contains the evolution of pressure, temperature and rates simulated at
the well. Maximize it:
Fig. C03.1 • Well#1 output gauges
C03.3 • Looking at Field Results
Maximize the cross-section plot, zoom in the vicinity of the well using , and set the display
to temperature. Set the color scale to:
