Page 19 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011 Ecrin Guided Session #1 • EcrGS01 - 17/36
Fig. C01.23 • View Plot – Well #1
C01.5 • Pressure Data Update
We will now proceed and update the partially loaded pressure. You can update a data set in
two different ways:
 Right click on EcrGS01p Filtered data node, and select the 'Filter last data' option
from the popup menu or from the plot toolbar, or
 In the main toolbar, click on the 'Update all' button , the update process will be
triggered provided EcrGS01p has its 'Dynamic Update' flag set to 'ON'. Right click
on and select the option 'Set Dynamic Update ON'. will then
display a green play mark which means that it can be dynamically updated. You can also
access this option by right clicking on the node to choose the option
'Properties' from the popup menu. Set the 'Status' option to 'ON' instead of 'OFF'.
In this case, Diamant will scan through the document to update ALL the data sets for
which the 'Dynamic Update' flag is set to 'ON'.
Choose to update the pressure data set using the popup menu. Diamant will scan through the
file (the path is stored for each specific data set) and start the loading process from the last
recorded data point (Figure C01.24). The last filtration parameters used during the previous
load have been memorized and are used. Validate with OK and at the end of the process,
Diamant reports a summary of the data update (Figure C01.25).