Page 10 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011 Ecrin Guided Session #1 • EcrGS01 - 8/36
Load - Step 2: Data Format
When selecting the BLI File, the content of the file is displayed.
Fig. C01.9 • Loading the OIL Rate
Start the load . Diamant scans one point every 1000 (this parameter can be
changed in the 'Loading Data' option in the 'Settings' control panel). Ecrin will detect
automatically that a large number of points are being loaded and therefore an intermediate
filtering step is needed, as can be seen with the checkbox ‘filter’.
Load - Step 3: Filtration Process
Once the initial scan is completed, Diamant displays the filtering dialog which allows the
following steps displayed by the various tabs.
 Input file statistics
 Preview and Load Window
 Pre-load
 Filter
 Load
You can change the scanning scheme for ‘Quick Stats’ (in this case one every 24 hours) by
changing the duration between two scanned points ('Re-calculate Quick Stats scanning one
data every...'), before clicking on the corresponding calculate icon. The software reads the file
at the appropriate sampling rate and stores this sample in memory.
On this basis, an estimate of the number of points, and the spanned intervals (X&Y) are made.
The next figure illustrates the results of this step.