Page 56 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011 Diamant Guided Session #1 • DmtGS01 - 18/19
You can also access the Data 'Properties' option by right clicking on the node to choose the
option 'Properties' from the popup menu. Set the 'Status' option to 'ON' by clicking on 'OFF'
which will open the combo box allowing the selection.
In this case, Diamant will scan through the document to update ALL the data sets for which the
'Dynamic Update' flag is set to 'ON'.
Choose to update the pressure data set using the popup menu. Diamant will scan through the
file (the path is stored for each specific data set) and start the loading process from the last
recorded data point (Figure C01.22).
The last filtration parameters used during the previous load have been memorized and are
used. Validate with OK and at the end of the process, Diamant reports a summary of the data
update (Figure C01.23).
Fig. C01.22 • Load from last
recorded point
Fig. C01.23 • Update Data Summary
The 'Well #1' view plot displays the entire pressure data set as one can see on Figure C01.24
below.
If the entire pressure data are not displayed, click on the Zoom reset icon .