Page 54 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011 Diamant Guided Session #1 • DmtGS01 - 16/19
When the filtering dialog appears continue to click and accept the defaults until the
'Filters' tab is displayed. The option 'Intermediate approach (15 sec)' is already checked, leave
the filter settings as their defaults suggested by Diamant. Check the post-filtration with
defaults, click the 'TEST' button, and then proceed to .
For the sake of illustrating the 'Dynamic Update' option in Diamant, we will the
loading process, approximately half way before completion. This time, do not resume loading
after the interruption, but choose the 'Stop but keep current data' option.
Fig. C01.20 • Loading Pressure
From the data browser, select EcrGS01-Pressure and choose the 'View Plot' display mode:
Pressure data are shown as points by default as opposed to the rates that are shown as steps.
Click on the icon and change the appearance of the pressure data from orange points to
red points, click on the button in the data set properties dialog, and change the screen
appearance to red.
Select the 'Well #1' node and hit the ‘Show/hide
data set’ icon in the toolbar.
This option allows you to select the data set that
you wish to display.
You can either enable ‘EcrGS01-Pressure’ or press
the ‘Show all’ button. Hit OK to confirm your
selection.
The plot is updated and now includes both the oil
rate and the (incomplete) pressure data set as
seen on Figure C01.21.