Page 372 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011 Rubis Guided Session #3 • RubGS03 - 8/22
Edit the producer geometry by selecting it in
the table and clicking on the ‘Geometry’
icon. In the ‘Producer – Geometry’ dialog,
reset X and Y to 0 ft:
Then move to the ‘Cross-Section View’ and
click on the Adjust Well trajectory button
( ) to correct the well path and make it
intersect the entire reservoir:
Repeat the same operation on the four injectors – manual modification of the coordinates and
trajectory correction – with the following coordinates:
Well X (ft) Y (ft)
Inj NW -4500 4500
Inj NE 4500 4500
Inj SE 4500 -4500
Inj SW -4500 -4500
B01.4 • Well Perforations
Back to the ‘Reservoir – Wells’ dialog select the Producer well in the table and click on
‘Perforations’. In the ‘Producer – Perforations’ dialog move to the ‘Cross-Section View’ tab and
use the ‘Create new perforation’ button ( ) to create two perforations as shown below – the
first perforation in the ‘Middle 2’ layer (green), and the second perforation across the two top
layers: