Page 363 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011 Rubis Guided Session #2 • RubGS02 - 15/16
The plot clearly shows the pressure difference between the upper and lower layers in the
vicinity of the well during the build-up, explaining the simulated crossflow. Note as well that
the dead zone (Layer 2) is ignored by the simulation 3D grid.
B02.4 • Copying the Model results Back to Topaze
Get back to the initial Topaze document by clicking on in the main Ecrin toolbar.
Re-extract the Topaze production without well
intake correction – to achieve this, click on
‘Extraction’ in the ‘Analysis’ page and uncheck the
‘Use intake’ box:
In the following dialog chose to delete the model
data:
Open the Ecrin browser ( ) from the main Ecrin toolbar, and develop the ‘Simulation Output’
node on the Rubis side, and the ‘Analysis’ node on the Topaze side:
Fig. B02.13 • Ecrin browser