Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011
Rubis Guided Session #1
• Rub
GS01 - 28/33
In the later display, one can clearly see that the bottom part of the reservoir is filled with
water, and that the reservoir does not contain any initial free gas.
This may also be checked in the Cross-section plot: maximize this plot, and select ‘saturations’
as the property to be displayed:
Fig. C02.4 • Initial saturations field displayed in the Cross-Section plot
C03 • Simulation: Run Simulation and Results Visualization
C03.1 • Run Simulation
Click on ‘Simulate’
to start the simulation thread: the simulation is initiated and results
are displayed in real time as the run goes on. Note that it is possible to perform any action on
the output plots (delete, create new, maximize, zoom in, etc...) as the simulation runs. The
complete simulation should be performed with approximately 250 time steps. A run summary
and some primary results (reserves, total cumulative production at the wells, etc...) can be
obtained by double-clicking on the Simulation status window:
1...,332,333,334,335,336,337,338,339,340,341 343,344,345,346,347,348,349,350,351,352,...485