Page 245 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.30 - Doc v4.30.01 - © KAPPA 1988-2013 Saphir Guided Session #9 • SapGS09 - 21/21
To create a cross section that shows the well use the button and trace through the well
and the nodes in the 2D Map. The nodes will turn green as the automatic ‘glue’ to the node is
activated, a click will snap the cross section to the node.
When defined, go to the Simulation tab, press grid, accept the defaults.
Maximize the 3D geometry plot.
Zoom on the well.
Click on , select the cross-section tab and enable the cross section and in the Display tab,
select the ‘lines’ display.
Zoom and orient the 3Dmap in necessary, to display the complex 3D grid:
Fig E01.13 • The complex 3D grid for the wiggly well