Page 238 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.30 - Doc v4.30.01 - © KAPPA 1988-2013 Saphir Guided Session #9 • SapGS09 - 14/21
Once the model has been generated an additional plot is available for analysis. Maximize the
2D geometry plot and zoom in on the well. Create a cross section through the well by clicking
on in the toolbar and joining the dots where the well coordinates were defined. When the
dot turns green, the mouse should be released and the cross section dragged towards the next
dot. The end of the cross section is defined by double clicking on the mouse.
Fig. D01.2 • Cross section creation in 2D geometry plot
Open the plot settings dialogue by clicking on in the toolbar or by right clicking the mouse.
Check the box ‘values’ and press . Click on to skip to the last time step. Now click
on in order to view the pressure profile at different depths by scrolling up and down. Recall
that the 2 perforated segments were 50 ft and 75 ft below the top of the reservoir. Scroll to
view the reservoir at relative depths 0.5 and 0.75 to view the pressure profiles near the
wellbore for both segments.