Page 173 - KAPPA - Ecrin v4.30 tutorials

Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011 Saphir Guided Session #3 • SapGS03 - 11/13
Fig. D01.4 • Model dialog and loglog response
Maximize the Geometry plot. You can play back the evolution of the pressure fields if you wish.
Use the icon to create a cross section plane, illustrated in the 2D Map as a blue line,
Figure D01.5 left.
Then click on icon to switch to a 3D display of the model. The color shading represents the
pressure value and the vertical scale the thickness. Figure D01.5 right. Use the display settings
icon to change the 3D setup.
In order to obtain a similar 3D display to that shown in the Figure D01.5 right, you may have
to use the icon, decrease vertical gain, and the icon, increase vertical gain. Keep those
icons pressed until the desired result is obtained. The zoom options in the plot specific toolbar
have a different behavior than the classical zoom options (click and drag):
Zoom out, Zoom reset, Zoom in, nudges the graphics in and out.
Fig. D01.5 • Building 3D display