Ecrin v4.20 - Doc v4.20.01 - © KAPPA 1988-2011
Saphir Guided Session #1
• Sa
pGS01 - 1/12
Saphir Guided Session #1
A01 • Initialization
This chapter is an introduction to the basic features of Saphir. It is assumed that you have
installed Ecrin workstation or Saphir stand alone to follow this session. The session can be
followed in all levels of Saphir except the Saphir reader.
Note:
By default, the plot ‘Always show scales’ option is on. In this guided session, it has been
turned off (in Settings – Plot Aspects - Plots tab).
The session will use the following files installed in the example directory during the main
installation of Saphir or workstation Ecrin: SapGS01.rat, the rate file and SapGS01.pre, the
pressure file. The extension to the files is not important here as any ASCII file can be loaded
by the application.
If the workstation mode has been installed click on the icon
in the application toolbar
and then new
. If Saphir has been installed as a standalone application,
click on new project directly. This opens in succession two dialogs:
Fig. A01.1 • Initialization dialog 1 of 2
This dialog allows you to choose the test type, reference fluid type, the available fluid rates,
net drained thickness, well radius and average porosity. Set the reference time to
Dec 4, 1999 at 00:06:45 hours
. Keep all other parameters as the suggested default.
1...,133,134,135,136,137,138,139,140,141,142 144,145,146,147,148,149,150,151,152,153,...485