Basic HTML Version
Ecrin v4.12 - Doc v4.12.02 - © KAPPA 1988-2009
Saphir Guided Session #3
•
SapGS03 - 12/13
Let us look at the cross section in 3D that was defined by the cross section plane blue line in
the 2D Map. Click on the display settings icon and choose the tab
, enable the
vertical cross-section by clicking on
and check that the line below (‘erase before’) is
also checked. Click on Apply a first time to obtain the display shown in Figure D01.6 left, then
check the
tag and click on Apply again to visualize the cross-section only (Figure
D01.6 right):
Fig. D01.6 • Cross sections
D01.4 • Other wells
Up to now only the tested well had a declared production and all the simulation runs were
without the influence of any other well. The fact that well P03 was fractured was however,
taken into account in all the runs. The simulation returns the response in the tested well,
however the response in all the declared shut-in wells in the field is also accessible from the
geometry plot by a double click on each well.
Let us define a production for well P03:
200
hrs 1500 STB/D, 200 hrs 5000 STB/D, 200
hrs 0 STB/D, 200 hrs 7000 STB/D, 200 hrs 0 STB/D
. Double click on the well in the 2D
Map and enter the rates manually in the
tab.
Click on the Model and make sure you check the option 'add other wells', generate the
response.
Hit the 'New plot' icon in the analysis toolbar ( ) and select the '2D geometry' option. Double
click on the P03 well in the new 2D geometry plot and the corresponding history plot is
displayed.